© 2017 TIRE PRESSURE CONTROL. 

START UP

During the start-up process, the Operator Control Unit will go through the following steps... OPERATOR WARNINGS

        e.g.   "OPERATOR CONTROL MUST BE ON AT ALL TIMES WHILE VEHICLE IS MOVING" 

                 "ALL WHEEL VALVES MUST BE OPEN BEFORE OPERATING VEHICLE" 

APPLICATION # AND DESCRIPTION 

        e.g.   APPLICATION 1    Summer Haul 

CURRENT PRESSURE SETTINGS/DESCRIPTION

        e.g.   SETTING 5

                 Haul Road Loaded

                 D - 65 PSI     T - 55 PSI 

START UP

NORMAL OPERATIONS DISPLAY

 

After the startup process is complete, the following will be displayed... 

    e.g. AXLE     STATUS     PSI

           Drive         DEF         70

           Trailer       O.K.         55

The STATUS display will indicate whether the axle group is inflating (INF), deflating (DEF) or at the set pressure (O.K.). The PSI display will indicate the current pressure of that group.

At preset intervals, the SETTING # and DESCRIPTION (also displaying PRESSURE SETTINGS, MAX SPEED and TIME ALLOWED) will flash

NORMAL OPERATION DISPLAY

TRAILER CIRCUIT OVERRIDE

 

This function is used only with a system that has a trailer control circuit when pulling a trailer that is not equipped or not to the connected truck.

Non-equipped or non-connected trailers will cause the TRAILER "AIR FLOW RESTRICTION" alert to activate. Push & Hold the CANCEL button for 2 seconds until a single beep is heard. The alert stops & the trailer circuit will be de-activated (trailer STATUS flashes ****).To resume normal operation, Push & Hold the STOP button for 2 seconds. 

TRAILER CIRCUIT OVERRIDE

CHANGING SETTINGS

 

Pushing       or       once will display the current PRESSURE SETTING # and DESCRIPTION. To change the setting, repeatedly push       or       to scroll through the settings. 

Stop at the desired PRESSURE SETTING and the controller will automatically accept this setting.

CHANGING SETTINGS

CHANGING THE APPLICATION

Push the menu button once. Push enter. Scroll up or down on the       or       to the desired application. Hold enter for 2 seconds until a single beep is heard and release. The new application is confirmed & current pressure setting is displayed. Change setting as required. Push enter again.  

CHANGING THE APPLICATION

SAFETY WARNINGS

        LOW AIR SUPPLY
If the Air Brake Pressure drops below a safe level, the LOW AIR SUPPLY WARNING will sound and flash. The system will be inoperable until the air brake pressure builds to an acceptable level. 

 

        TIRE PRESSURE LOSS
If a loss in tire pressure occurs and the system is not able to maintain pressures, the TIRE PRESSURE LOSS alarm will sound and flash the specific tire group where the loss is occurring. Stop the vehicle immediately and shut off all wheel valves. 

 

        OVERSPEED CONDITION
If a vehicle exceeds the speed set point for a specific PRESSURE SETTING, an alarm will sound and flash. The operator must then slow down or change PRESSURE SETTINGS. If the alarm continues, the system will automatically change the PRESSURE SETTING to the next higher level

SAFETY WARNINGS

Products

Click to enlarge graphic